Merry F'n Christmas

[Badass]

i have been havin a rattle out of the two rear doors. i have tried adjusting both the pin and the latch with no luck so her is what i ended up doing
i got some 3/8 od fish tank type hose from the local hardware for $.25/ft. i got 30 ft for 2 doors.
first remove the sill panel. it just clips on.

then mark the split in the seal. remove seal. it just pulls off.

i didnt have a fish tape so Nut brouoght me by some 10ga hard wire. i used soapy water as lube and inserted the wire. taped it to the tube and pulled it through keeping it soapy.




















fixed

[bucketobolts]

That's using your noggin' for something other than a hat rack...great job!

[Badass]

this has actually worked great!! the tube is not tight in the WS so it still seals the door well. all this does is add a little stiffer resistance when the door is shut. this woulld work with just about any vehicle with this type weather stripping.

[broncomatt]

Nice work. Awhile back nissan had a simular problems with the quest. As part of the recall we put a small slice in the door seal and slid a section of rubber hose into the seal.
Glad you got yours fixed.